Page 44
Cleaning
optoNCDT ILR 1183
10.
Cleaning
Remove dust from optical surfaces (transmitter and receiver optics) with a blower brush.
Do not use cleaners that contain organic solvents, when wiping optical surfaces down
Contact the manufacturer in the case of stubborn contamination or soiling.
Avoid the use of any kind of solvents to clean the sensor.
> Damage of the sensor
Do not open the device. Do not loose any screw at the sensor
> Damage of the sensor
11.
Liability for Material Defects
All components of the device have been checked and tested for functionality at the factory. However, if
defects occur despite our careful quality control, MICRO-EPSILON Eltrotec or your dealer must be notified
immediately.
The liability for material defects is 12 months from delivery.
Within this period, defective parts, except for wearing parts, will be repaired or replaced free of charge, if the
device is returned to MICRO-EPSILON Eltrotec with shipping costs prepaid. Any damage that is caused by
improper handling, the use of force or by repairs or modifications by third parties is not covered by the liabil-
ity for material defects. Repairs are carried out exclusively by MICRO-EPSILON Eltrotec.
Further claims can not be made. Claims arising from the purchase contract remain unaffected. In particular,
MICRO-EPSILON Eltrotec shall not be liable for any consequential, special, indirect or incidental damage.
In the interest of further development, MICRO-EPSILON Eltrotec reserves the right to make design changes
without notification.
For translations into other languages, the German version shall prevail.
Summary of Contents for optoNCDT ILR 1183
Page 6: ...optoNCDT ILR 1183...
Page 47: ......
