MICRO-EPSILON optoCONTROL CLS1000, Operating Instructions Manual

Page: 30 / 52

Page 30
Operation
optoCONTROL CLS1000
5. Operation
5.1 Initial Operation
Install the optoCONTROL CLS1000 controller as per the installation instructions , see 4.1 .
Connect the controller to the downstream display or monitoring units and to the power supply.
The sensor may only be connected to peripherals when it does not carry power, that is, only when the
supply voltage has been switched off.
The green LED is illuminated after the supply voltage is activated.
5.2 Membrane Keys
Aside from the LED, the controller also has a display and membrane keyboard , see 4.4 via which the controller is operat-
ed.
The most important settings and controller operations can be activated via the keys and then displayed.
1
2
3
4
5
6
1 Field in display Display Meaning Model
ON1 Illuminated Q1 active AU, AI, 2Q, OC
QN active QN
ON2 Inactive, no display AU, AI, OC, QN
Illuminated Q2 active 2Q
TRG Illuminated Trigger active
Illuminated Lock = active
Small numeric display Switching value / current menu item
Large numeric display Measurement value / measurement value
selection
Off Concluding the
teach-in process
Flashing Active teach-in process
2
6 Buttons for navigating the menu items and
changing values
3 LED green Constant
supply voltage
Off No supply voltage
4 Button for selecting/confirming menu item/
value.
Deactivate the key lock by pressing for
2 seconds
5 Button to undo the menu selection or go
back one menu level; to abort or discard