17
©2022 Micro-Air Corp
March 21, 2022, revision 1.0
Dip Switches
This setting is used to
configure your thermostat’s operation
al settings and is slightly
different for each EasyTouch RV model. Some simply display how the air conditioner
control board that EasyTouch RV communicates with is configured. Others allow for
telling EasyTouch RV what appliances it has connected to it. Tap the Switches button to
see what configurations are available. See section
what must be configured, if any.
Auto-Generator Start (AGS)
Warning
for
configuring this behavior where appropriate.
This setting allows for a generator to start prior to any appliances that need line voltage
to run. EasyTouch RV will output voltage to its pin 3 grey wire to go to existing AGS
hardware, prior to calling for any appropriate cycles. It then disconnects voltage from this
wire when it is no longer needed. Tap the AGS Enable button to green to enable this
behavior or to gray to disable it.
Furnace/Aqua Icons
Most RV systems have auxiliary heat modes in the form of a
“forced
-
air”
gas furnace or
hydronic heat. EasyTouch RV or the associated control board treats these as the same
output and so you can tap the Furnace/Aqua button to toggle between what icons to
display for this operational mode. This is simply a cosmetic setting for all EasyTouch RV
models except the 350 model, which should be set appropriately.
Switches Button
AGS Enable Button
Furnace/Aqua
Button
