Manufacturer: ATEXOR OY
P.O.Box 89, FIN-60101 SEINÄJOKI
Tel: +358-207 343 250
Internet: www.atexor.com
IL-640
IL-640 EM
IL-6400
User Manual
Please read this manual carefully in order
to experience the full benefits of your lamp.
Please store the manual for later use.
USING THE LAMP
The charge of the lamp’s battery will be reduced when the lamp is stored. The lamp must be carefully
charged prior to use by using a MICA ILC4 charging stand. The battery will be charged from empty
to full in 6 to 12 hours, depending on the temperature and condition of the battery. A new battery will
reach its full capacity when it has been fully charged and discharged about ten times.
The first
charging of a new lamp must take at least 12 uninterrupted hours!
OPERATING MODES
A pushbutton controls the functions of different lamp models as follows:
IL-640:
LOW-POWER -> FULL-POWER -> OFF
IL-640 EM:
LOW-POWER -> FULL-POWER -> OFF. If the lamp is in the charging stand and a power
failure occurs, the lamp is automatically lit at LOW-POWER.
IL-6400:
LOW-POWER -> FULL-POWER -> OFF. Boost is available when the lamp is switched on.
IL-6400
is equipped with a “Boost” function which is activated by holding the button down. IL-6400 will
provide over 50% more light in Boost mode compared to FULL-POWER, but it is intended to be used
only briefly to prevent overheating. The function stays on for as long the button is held down.
IL-640 EM SAFETY LIGHT
The light will be automatically turned on when the lamp is in the charging stand and the charging
power is cut off (power failure, etc.). IL-640 EM is always automatically in safety light mode when
placed in the charging stand.
