Mi-T-M HEO Series, Operating Instructions Manual

Page: 16 / 94

6 Operator's Manual
preparatiOn
attire:
Proper attire is essential to your safety. It is advised to utilize whatever means
necessary to protect eyes, ears, and skin. Additional safety attire (such as
respiratory mask) may be required when using detergent cleaning agents with
this pressure washer.
pre-start:
. Check to ensure the voltage is on.
2. Pump oil level should be checked before each use. Check the oil level with
the dipstick on top of the pump crankcase. (See illustration #6.) The proper
oil level should be at the notch on the dipstick. If the level appears low, use
pump oil SAE20 or 30 non-detergent.
3. Inspect the water inlet strainer. Clean or replace if necessary. See "Water
Supply", #6, pg 14.
iLLustratiOn #6
puMp-rear OiL gauge
Burner fueL tanK:
1. Review "Risk of Explosion or Fire" pg. 4, before fueling.
2. Locate the Safety Decals on your unit and heed their warnings.
3. Fill the burner fuel tank with good quality, clean No. 1 or No. 2 fuel oil/diesel
or kerosene. Do not use gasoline!
unLOaDer:
The unloader has been preset at the factory and should only be adjusted by a
trained serviceman.
WARNING
risK Of eXpLOsiOn Or fire!
aLWaYs stOre fueL aWaY
frOM tHe WasHer WHiLe tHe
unit is running Or HOt.
DANGER
risK Of fire!
-DO nOt sMOKe WHiLe
fueLing!
-DO nOt fiLL tHe fueL tanK
WHiLe unit is running Or
HOt. aLLOW unit tO cOOL
fOr tWO Minutes BefOre
refueLing.
-DO nOt fiLL fueL tanK tO
pOint Of OVerfLOWing.