CA-Series Operator’s Manual
3
warning
tHe following pages contain operating and
maintenance instructions.
do not attempt to operate tHis pressure
wasHer until you Have read and understood
all safety precautions and instructions
listed in tHis manual.
incorrect operation of tHis unit can cause
serious injury!!
do not alter or modify tHis equipment in any
manner!
pre-start inspection procedures:
Before starting the unit, perform the following procedures:
. Check the oil level in the pump and engine.
2. Inspect the water inlet strainer. Clean or replace if necessary. See “water
Supply”, #2, pg. 2.
3. Check all hose connections to ensure they are securely tightened. See
“water Supply”, #3, pg. 2.
4. Inspect for system fuel leaks. If a fuel leak is found, DO NOT START
UNIT! See “Fire & Ventilation Precautions”, #2 and #4, pg. 4. Be sure
that all damaged parts are replaced and that the mechanical problems
are corrected prior to operation of the unit. If you require service, contact
Customer Service.
5. Inspect high pressure hoses for kinking, cuts and leaks. If a cut or leak
is found, DO NOT USE HOSE! Replace hose before starting unit. See
“Miscellaneous Safety Precautions” #6, pg. 6. Be sure that all damaged
parts are replaced and that the mechanical problems are corrected prior to
operation of the unit. If you require service, contact Customer Service.
installation & preparation
