MH RYZ 50 Cross C, Service Manual

Page: 25 / 92

RYZ
• Changing the brake disk.
N.B.:
In refi tting, respect the order of assembly: mark the outer
side and fi t the six self-locking bolts.
• Changing the wheel bearings.
• Changing the speedometer take-off.
FRONT BRAKE
N.B.:
The brake pads are identical; on dismantling without re-
newing, identify the fi tting direction and refi t in the same
direction.
DISMANTLING THE FRONT BRAKE CALLIPER
AND BRAKE PADS
Remove the two bolts (1) from the calliper on the fork arm.
Remove the pins (2).
Remove the brake pads (3) and the anti-vibration plates (4).
FORKS
1)
2)
3)
WARNING:
As a result of removing the wheel, the calliper or the
brake pads, and before performing a road test, check the
good functioning of the brake by applying the brake lever
various times.
CHASSIS 4-3
4
CAUTION:
• Place the machine on a fl at surface.
• Stand the machine on a suitable support, in such a way
that the front wheel is off the ground.
• Do not activate the brake lever during the dismantling
and refi tting process.