10. Rear Wheel Axles [See Maintenance Schedule]
The rear wheel stub axles need to be lubricated regularly. Remove the rear wheels by depressing
the spring clip and at the same time pull off the wheel. Apply Petroleum Jelly or light grease to
the stub axles. Use a very small amount as the grease can attract sand. If you play in sandy
conditions you should clean your axle and regrease fortnightly.
To refit the rear wheels you will need to align the wheel
’s four sided slot to the axle pin to ensure
the wheels are properly engaged.
11. Upper & Lower Bag Straps [See Maintenance Schedule]
The bag straps should be replaced as per the Service Schedule. The upper bag strap can be
replaced by:
1. Removing the left and right hand straps form the upper bag support
2. Undo and remove the screws holding the strap in position on the bag support
3. Remove and replace both bag straps
4. Insert bag strap securing screws
12. Correcting the Alignment of your Motorised Buggy
If during use, under Top Box control you find that the buggy veers to the right or left, please follow
the instructions below to correct this problem:
1. If the buggy veers to the left, face the front wheel of the buggy and use the Allen
key provided to screw the right bolt clockwise or the left bolt anti-clockwise.
2. If the buggy veers to the right, face the front wheel of the buggy and use the allen key
provided to screw the left bolt clockwise or the right bolt anti clockwise. Test run the buggy
and repeat the process until the buggy runs straight.
3
