MG Energy Systems B.V. | Foeke Sjoerdswei 3 | 8914 BH Leeuwarden | The Netherlands
+31 (0)58 750 89 47 | [email protected] | www.mgenergysystems.eu
Innovation
in energy storage
9.2
Updating
The firmware of the MG Energy Monitor can be updated using the MG Diagnostic Tool. Contact your
supplier for more information.
WARNING:
Updating the Energy Monitor will take some time. Do not disconnect the device
from the system or turn the system off while the update is in progress.
NOTICE:
The instructions in this section assumes the MG Diagnostics Tool software is
already installed and configured on a computer. If in this section a reference is
made to “computer”, the computer running the MG Diagnostics Tool software is
meant with it.
For a full instruction of the MG Diagnostic Tool refer to the manual of the
software.
Updating procedure
1.
Connect a USB to CAN transceiver to the same CAN-Bus as the monitor.
2.
Connect the USB-connector of the USB to CAN transceiver to the computer.
3.
Start the MG Diagnostic Tool software on the computer.
4.
Make sure the system is powered on and is remains on during the update. If this can’t be
maintained please connect external mower to the monitor.
5.
Navigate to the spectator tab in the MG Diagnostic Tool.
6.
Click the update button for the preferred Energy Monitor.
7.
The MG Diagnostic Tool will ask for confirmation to update to the new firmware version.
8.
The Energy Monitor will shut-down and perform the firmware update.
9.
When the update was successful, the monitor will start-up automatically.
