Instruction Manual MFJ-1432
VHF/UHF Dual Band
Mobile Antenna
Before operating this unit, please read these instructions completely.
The MFJ-1432 mobile antenna comes in two pieces. Install the upper whip
into the coil and tighten the allen screw with the wrech provided. Be sure all
allen screws are tight before installing the antenna to a mount. There are 2
allen screws per coil.
Screw antenna tightly onto one of the approved MFJ mounts. The MFJ-
1432 is compatible with most SO-239 and NMO mounts.
If you are using the MFJ-333BM or MFJ-335BM (NMO mounts) you will
need to use the NMO to SO-239 adaptor. Be sure the adaptor is tightly
screwed to the base and be sure the antenna is tightly screwed to the
adaptor.
To operate the fold-over feature, pull straight up on the antenna whip. After
the raising the whip about an inch, gently fold the antenna at a 90 degree
angle. Use this feature to avoid knocking the antenna off when entering low
clearance areas.
