1
2
3
5
4
22
Folding down the back support
Fold open the safety latch (2) first for folding
over the back support [1], then remove the
pin (3).
☞
All the while hold the back support in
position with one hand on the push bar
or handle in order to prevent it from tilt-
ing over to the back.
☞
The loose distancers might fall and roll
off. – Do not loose the distancers!
Afterwards fold the back support down [1].
☞
Reinsert the pin after releasing the gas
spring for the back support [4], in order
to prevent loss of it and also the dis-
tancers.
Unfolding the back support
After raising the back support [4] lift the gas
pressure spring back up and hang it into
place. Then insert the pin (3) and distancers
and fold the safety latch (2) to closes posi-
tion [5].
☞
Check the locking device after raising
the back support up and reinserting
the pin.
☞
Keep the pin clean at all times for flaw-
less function.
