1
2
3
21
BACK SUPPORT WITH AN-
GLE ADJUSTMENT
A back support with a gas-pressure spring
may only be reclined to the rear when the
multifunction and bearing wheelchair is
parked on an even and firm surface.
Before any actions on the back support
adjustment the multifunction and bear-
ing wheelchair is to be secured against
unintentional rolling motions.
☞
Adjusting the angle of the back
support
The angle of the back support [1] is contin-
uously adjustable through the pneumatic
spring [2].
Activate the right lever (3) on the push han-
dle for continuous angle adjustment of the
back support.
☞
In doing so use both push handles,
resp. the push bar as a lever and adjust
the back support accordingly. – Danger
of overturning!
☞
The adjustment should only be car-
ried out under the weight of the
user.
After the angle adjustment release the lever
(3).
☞
Check to ensure that the back support
and seat unit are locked in place.