Meyra 1.610, Maintenance And Service Manual

Page: 78 / 104

78
Seat height, model 1.617
Replacing the adjustment motor for seat height
Drive the seat into the highest position and secure it in
place in order to replace the adjustment module (1) for seat
height.
1. Pull the connection plug of the corresponding adjust-
ment motor (1) off of the adjustment module [2].
2. Remove the respective bolt (3) + (4) for attachment of
the adjustment motor for seat inclination.
☞
In doing so watch for cables that might still be attached.
– If required, remove corresponding cable binders.
3. Assembly of the adjustment motor is done analogue in
reverse order.
!
Attention:
It is to be observed that the cables are not damaged or
bent when being placed.
☞
Otherwise danger of fire through short circuits!
☞
Previously removed cable ties are to be replaced.
☞
Then carry out a function test.
☞
Therefore observe chapter Functional checks on
page 94.
1
2
3
4