Meyer's MS485, Operator'S Manual / Parts Book

Page: 16 / 88

16 | P a g e M o d e l M S 4 8 5
PRE-OPERATION
GENERAL
Read th
e entire Owner’s Manual before attempting to operate this manure spreader. Before attempting any
maintenance or repairs; always be sure all rotating parts have stopped and that the tractor is shut off. Disconnect
the PTO, relieve all hydraulic pressure and disconnect hydraulic hoses.
WARNING
NEVER OPERATE SPREADER WITH ANY GUARDS OR SHIELDS REMOVED.
FAILURE TO HEED MAY RESULT IN SERIOUS PERSONAL UNJURY OR DEATH.
1. Completely lubricate the unit as described in the LUBRICATION Section.
2. Check and tighten the wheel lug nuts if required.
3.
Check and maintain the tire pressure according to the manufacturer’s recommendation.
4. Check the entire unit for loose bolts, damaged or loose hydraulic fittings and hoses or other damaged parts.
5. The tractor half of the PTO drive shaft assembly must be locked securely to the tractor output shaft.
TRACTOR HITCH AND PTO REQUIREMENTS
•
This spreader is designed to be operated by a 1000 RPM PTO. NO PTO ADAPTERS MAY BE USED.
•
The spreader is designed to be towed by a CAT 3 drawbar with a Ø1-
1/2” Pin Hole.
Ø2” Pins may be used with the articulating hitch option (with Ø1-1/2” insert removed).
•
The front PTO driveline assembly is equipped with an 80° Constant Velocity Joint.
DO NOT EXCEED THE MAXIMUM 80° TURNING ANGLE
•
The PTO drive shaft assembly is designed to operate with tractors conforming to the
standards shown on Figure 1.
•
Test PTO travel by turning tractor in both directions. The telescoping driveline assembly
should meet the MIN-MAX dimensions shown in Figure 2.
FIGURE 1. TRACTOR DRAWBAR & PTO SPECIFICATION
A- 10” Minimum
B- 15 ” - 22”
C- 16 ” - 19”