Form 1-1151
July 2016
SAFETY DEFINITIONS
Meyer Products LLC reserves the right, under its continuing product improvement program, to change construction or design details,
specifications and prices without notice or without incurring any obligation.
OVERHAUL
and
SERVICE INFORMATION
are covered on separate instructions.
End user must be given this instruction sheet prior to delievery of this Snow Plow.
PARTS & INSTALLATION INSTRUCTIONS
MDII™and EZ MOUNT PLUS™
SNOW PLOW MOUNTING 17195
2017 & Later FORD F250 thru F550
4x4 MODELS
Snow Plow Preparation Package 86M
Meyer Products LLC
6 Angell Lane • Damariscotta, ME 04543-4507
Phone 563-2227(Area Code 207)
www.meyerproducts.com• email [email protected]
© 2016 Printed in the U.S.A.
Meyer Products LLC
18513 Euclid Ave. • Cleveland, Ohio 44112-1084
Phone 486-1313 (Area Code 216)
www.meyerproducts.com• email [email protected]
This is the safety alert symbol. It is used to alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol to avoid possible injury or death.
DANGER Indicates an imminently hazardous situation which, if not avoided, will result in
death or serious injury.
WARNING Indicates a potentially hazardous situation which, if not avoided, could result
in death or serious injury.
CAUTION Indicates an potentially hazardous situation which, if not avoided, may result in
minor or moderate injury.
CAUTION used without the safety alert symbol indicates a potentially hazardous situation
which, if not avoided, will result in property damage.
IMPORTANT NOTICE
In conjunction with FMVSS (Federal Motor Vehicle Safety Standards) and OEM (Original Equipment Manufacturer) guidelines,
Meyer Products has designed this plow package with the following guidelines:
Installation of a snowplow may effect your new vehicle warranty.
For more information consult your Vehicle Owner's Manual / Vehicle Dealer.
The vehicle must not be operated when overloaded. In all cases, the loaded vehicle weight, including the entire
snowplow system, all aftermarket accessories, driver, passenger, options, nominal fluid levels, and cargo must not
exceed the front/rear Gross Axle Weight Rating (GAWR), and total Gross Vehicle Weight Rating (GVWR). These
weights ratings are specified on the safety compliance certification label on the driver's side door opening. The use
of rear ballast weight may be required to prevent exceeding the front GAWR.
According to the NHTSA (National Highway Traffic Safety Administration) new and untitled vehicles need to be verified by the installer that
snowplow and ballast (if needed) do no exceed the front/rear GAWR and total GVWR.
Read the Meyer Owner's Manual before operating or servicing a snowplow.
FOLLOW THESE INSTRUCTIONS
EXPLICITLY.
GENERAL INFORMATION
SAFETY PRECAUTIONS
should be used when
Hydraulic Unit is in OPERATION
and plow is in a
RAISED
position.
Lower plow to ground when vehicle is PARKED in case of hydraulic failure.
Check contents against the parts list to determine all are correct and included, and also to familiarize yourself with them.
Warranty does not apply to a Meyer or Diamond product which has been negligently or improperly assembled or
installed.
CAUTION: To avoid harm to vehicles electrical system always
disconnect battery before beginning installation.
DO NOT BURN
holes or
WELD
vehicle frame. This may cause frame failure.
