Operating the product
20
Switching the LED field on and off
In standby mode briefly press the on / off button (4).
The product switches to the active mode and LED field on the front lights up.
To switch off the LED field again briefly press the on / off button (4).
After the LED field has been switched off the product again runs in standby mode.
To completely switch off the product, press the button (4) for approx. 2 seconds until the
LED field and the information in the OLED display go out.
Setting the brightness and colour temperature
each other.
The selection of the desired setting for the brightness and colour temperature is done using
the mode button (M) respectively (1).
By repeatedly pressing the mode button (M) (1) you can switch between, respectively select, the
setting for brightness [%] and colour temperature [K].
The actual selection is displayed by a pointer symbol ( > ) on the OLED display.
CAUTION
The product can cause damage to the eyes.
Never point the product directly at the eyes of people or
animals.
Adjusting the brightness
To set the brightness of the LED field, press the mode button M (1) so often until the selection
pointer ( > ) on the OLED display is next to the brightness symbol (sun). The brightness of the
LED field can be set between 5% and 100% in increments of 5%.
To increase the brightness [%] repeatedly press the plus button (3) or keep the plus
button (3) pressed down.
To decrease the brightness [%] repeatedly press the minus button (2) or keep the minus
button (2) pressed down.
