METVISA CFH.300 Series, Instruction Manual, Page: 12 / 28

12
4.3 Operating Procedures
Before operating your equipment, remove the protective rubber from the cutting disc and
clean the components that will come into contact with the food (fasteners, gutter, base coating,
protection for the sharpener and deburring, etc.), for this, make sure that that the equipment is
disconnected from the mains, only then carry out the disassembly. Follow the cleaning instructions in
item 5 of this manual.
Check the disassembly and assembly procedure described below:
•
Disassembly : Disconnect the equipment from the mains. To remove the structure, rotate
the handle (located on the front and back of the equipment) to unlock, then pull the structure out. With
your hands positioned at either end of the movable table, lift the table with both hands at the same
time. Only after removing the mobile table will it be possible to remove the protection of the sharpener
and deburring, where an appropriate tool will be needed to remove the screws.
To remove the drive disc, pull it up through the bearing.
Note: This procedure is used to clean the cutter disk and the tray (fixed inside the cabinet) daily.
•
Assembly : The assembly procedure is the reverse of disassembly. Fix the protection of the
sharpener and deburring with the screws. When assembling the moving table, the transverse groove
must be fitted into the bearing located above the drive disc (parts marked in yellow), at the same time
the rail must be fitted into the plastic groove. Make sure the rail is positioned on the same side as the
cut adjustment handle. Finally, fit the structure by rotating the handle to lock it.