METVISA BIMG MCG8110M604, Instruction Manual

Page: 10 / 20

10
ATTENTION!
Be careful when adjusting the granulation. The handle cannot be tightened excessively, it must
simply be pressed against the end of the thread. Tightening it excessively will wear out and
strain the engine, possibly burning it.
The handle cannot be loosened too much either, as in this case a ball located between the
handle and the back of the head could come loose. Without the ball, the operator will have
difficulties to regulate the granulation. Do not adjust the granulation without the handle ball.
•
On/off Switch
– used to turn the equipment on and off. In position “1” it switches on, in position “0” it
switches off.
4.3 Operating Procedures
Before operating your equipment, disassemble the components (instructions below) that will
have contact with the grains (funnel and grinding head), and clean them. Carry out cleaning with the
appliance disconnected from the mains. Follow the cleaning instructions in item 5 of this manual.
Check the disassembly and assembly processes described below.
•
Disassembly: