Metso MP1000, Technical Reference Manual

Page: 21 / 180

SECTION 0 - SAFETY
MP SERIES CONE CRUSHER TECHNICAL REFERENCE MANUAL
0-13
the atmosphere. This vaporized fluid can quickly
become a mass of flames, resulting in severe burns
for personnel in the immediate area. Adequate
precautions should be made to avoid contact with
these components. Never perform welding or torch
cutting activities in the presence of flammable
materials. When cutting or welding on a plant with
gasoline or diesel units, cover fuel filler caps with
several layers of wet shop cloths.
Toxic, Corroding and Irritating Agents
Before handling chemicals, carefully read the
safety instructions from the supplier of the
respective chemical. Hazardous chemicals may be
in use. Wear protective clothing, gloves, boots,
glasses, and respirator when necessary.
Refer to the MSDS (Material Safety Data Sheets)
and Crushing Plant procedures for handling of
these materials.
Avoid prolonged contact with fluids, such as
gasoline, diesel fuel, hydraulic oil and cleaning
solvents, which may cause skin irritation or other
reactions.
Machine Inertia
Due to the large inertial forces of the Crushing
Plant and Crushing Plant components, the machine
can not be stopped abruptly. This is potentially
hazardous to personnel. All personnel must stay
clear of rotating elements and other moving parts
until the machine has come to a complete stop.
Regularly inspect the structural elements to
maintain safe operation.
Hot Surfaces and Fires
There are hot surfaces on Crushing Plants.
Protective gloves and coveralls help protect against
burns. Be aware of hydraulic system, hoses,
fittings, and pipes. Regularly inspect and observe
high temperature lines, and fluid lines for leaks or
damage. On mobile equipment be cautious around
the engine because of exhaust gases.
When in contact with hot temperatures, or when
heated themselves, some hydraulic oils may ignite
at around 392°F (200°C). Attention must be paid to
the condition of hydraulic hoses and couplings.
Remove immediately oil spills from floor,
walkways, and pits. Fix all sources of oil leaks and
clean up spills.
WARNING
Risk of injury. Fire may break out. Never
perform welding or torch cutting activities in
the presence of flammable materials.
NOTICE
All maintenance personnel who use cutting
and/or welding torches should be advised if
there are hydraulic components in the
immediate area in which they are working.
CAUTION
Contact Metso Minerals or its authorized
representative prior to any welding of major
Crushing Plant components such as main
frame, adjustment ring, bowl, etc.
Performing welding on the Crushing Plant
components can be detrimental. Before
welding, always verify that material is
weldable! Failure to do so may result in
weldment failure and present a risk of injury
and/or property damage.