IMO 3/20
8
IMO-503 EN
8.2
Piston assembly
1. Clean the piston. Apply RMEBS grease on rubber parts.
2. Place lip seal (14) on groove of piston. Place o-ring (18)
on inner counter face of piston rod. Finally insert the
piston rod (4) into the piston (3).
3. Apply drop of 7649 primer (dryer) on internal threads of
piston rod. Wait for a minute and again apply a drop of
242 loctite on same threads. Now tighten the piston rod
with the help of SHC screw (7) by using combination of
spring washer (9).
4. Insert this piston rod assembly carefully into the tube.
8.3
Front cover assembly
1. Clean it with liquid soap solution. After drying apply
RMEBS grease rubber parts.
2. Place rod seal (10) on its groove.
3. Place cushioning seal (11) and o-ring (13) on its groove.
Place o-ring (20) on cushioning screw (8), assemble the
cushioning screw on front cover.
4. Place the front cover on the tube, just push while
rotating to get fixed on it so that o-ring on the cover
should not get damaged while assembling.
5. Fasten the cylinder cover bolt (6) of front cover and
engage the lock nut (19).
NOTE: Operate the cylinder assembly by hand. It should be
free rotating piston rod & operating in and out.
Summary of Contents for JAMESBURY EASYFLOW SC Series
Page 11: ...IMO 3 20 IMO 503 EN 11 ...
