***READ ALL INSTRUCTIONS BEFORE USE***
VAC N BLO CAR VAC COMMERCIAL SERIES
Model PRO-83BA-CS
The PRO-83BA-CS can be mounted to a wall with the wall mount bracket (MVC-331). Ideally, the center holes should be used
to mount the bracket directly into a stud with the screws shown below. Mollies can be used to secure mounting bracket to
sheet rock if a wall stud is inaccessible. Level wall mount bracket in desired position and mark screw locations within screw
holes. Once bracket is securely mounted, the VAC N BLO can be hung by the wheel axle located on the suction side.
DELIBERATELY MADE BETTER IN THE U.S.A
®
***READ ALL INSTRUCTIONS BEFORE USE***
1 Insert the grounded Power Supply Cord into a grounded outlet.
2. Hose: the 30 ft by 1.5” Hose (MVC-56PRO-30) that is included, features one end cuff that is permanently “hot glued”. The
opposite hose cuff screws on and off. The end that is permanently attached will connect to steel tube on the suction end of the
Vac n Blo for cleaning purposes, or to the exhaust end for blowing purposes.
3.
Start your Vac N Blo by pushing the Toggle Switch from right to left.
4. When using the Hose (B), connect to the suction end to vacuum, and to the exhaust end for blowing.
5. The 1.5 inch “Claw” shaped Upholstery Tool (MVC-268FOR) and Crevice Tool (MVC-188) can be used on the 1.5 inch
removable hose cuff. These tools are to be inserted into the hose cuffs to be used properly.
6. To use the 1.25 inch attachments, the 1.5 inch removable hose cuff can be removed by unscrewing in a “clockwise” manner.
The 1.25 inch hose cuff will screw on counter clockwise. The 1.25 inch hose cuff is for use with the 2-20 inch Extension Wands
(MVC-194), Micro Cleaning Tool Kit (MVC-211E), Blower Nozzle (MVC-196AA), Floor Brush (MVC-190B), Inflator
Adaptor (MVC-211D), Upholstery Nozzle (MVC-185A), Dust Brush (MVC-206B), and Crevice Tool (MVC-188).
7. The Extension Wands (I) connect to the Hose (B) to reach those inaccessible places. Eliminate bending to reach low areas
and under furniture, and stretching to reach high places.
8. The Crevice Tool (C) allows you to clean those hard to reach places. It can be used for vacuuming and blowing.
