Metronome cAQWO, Owner'S Manual, Page: 9 / 20

3
3 Quick Start
The c|AQWO external power supply is adjusted at the factory for a nominal voltage corresponding to the
electrical network of your country.
Install the c|AQWO units on a Hi-Fi rack or on a stable and strong support.
Do not install the units directly on a carpet or flammable material.
Do not put any object on the top of the units.
Before starting open the remote control and insert the provided batteries.
A. Plug the digital source(s) to the digital inputs
B. Connect the analogue output to your amplifier or pre-amplifier
C. Plug the interconnect power connectors between the main unit and the PSU
D. Plug the PSU to the AC with the supplied power cord or a compatible cord
E. Start the unit with the main power switch, the screen lights up
F. Select the digital input on the touchscreen
G. Play your music !
Should it fail to operate:
- Turn off and unplug the units
- Check the fuses
- Start again the Quick Start procedure
- If there is no difference, please contact Métronome Technologie Factory.
The touchscreen should be alight when the unit operates.
The power supply can be switched on during a long period. Between listening sessions, please put the device on
stand-by. For a prolonged absence, it is advised to switch it off and unplug the unit from the AC network.
The power supply is protected by internal electronic circuits and by a general fuse located in the block near the
main cord beside the switch. To change the fuse, it is mandatory to unplug the main power cable before opening
the fuse compartment with a screwdriver. Then replace the fuse by the same model: 1A, temporised fuse (eq.
slow burn). NEVER CHANGE THE FUSE VALUE.