DL7, DL7L
29
Fig. 6.11 The incorrect way to wire a variety of sensors to IN3 module.
6.2.8 IN6D
– six channel binary inputs module
Fig. 6.12 Wiring diagram for IN6D module.
Terminal No
Description
1
5
9
13
17
21
+24V OUT (48 mA max (6x 8 mA))
Transducer power supply. Outputs are
protected by common resetable polymer 50
mA fuse.
2
6
10
14
18
22
PULS IN
Pulse signal input. Current limit in table below.
3
7
11
15
19
23
GND A
Signal ground
LED LED LED LED LED LED
LED indicator of the input state.
Notes:
The module IN6D standard current limit for inputs is set at 3.6 mA. In special cases, it is
possible to change the limit value using the jumpers located on the module board inside the
device. Available settings are in the table below. The setting apply to all six channels.
J1 J2
I MAX
0.45mA
1.5mA
2.44mA
3.54mA
