Back Plate Installation
With the Metrologic back plate
(Part #45473), position the scanner
in one of two directions. The two
Vertical Mount
orientation choices are vertical or
horizontal. (Refer to Figure 4). To
use this stand, use the four
6-32 x ½ inch machine screws and
Horizontal Mount
four wood screws to attach the unit
to the back plate and work surface.
The maximum distance the screws
Figure 4: Back Plate Orientation
should go into the scanner is a ½ inch.
1.
Drill four holes into the work surface that correspond with the
holes indicated by an XY in Figure 5.
2.
To fasten the scanner to the back plate:
z
For a
horizontal mount
, align the four holes on the back of
the scanner with the four clearance holes located on the
back plate marked with an X in Figure 5.
z
For a
vertical mount
, align the four holes on the back of
the scanner with the four clearance holes located on the
back plate marked with a Y in Figure 5.
3.
Fasten the scanner to the back plate by inserting the four
6-32 x ½ inch screws into the four holes in the scanner's case.
Fasten the scanner and back plate to the work surface.
Y
X Y
X
X
Y
Y
X
XY
XY
XY
XY
X = Scanner Horizontal Mount
Y = Scanner Vertical Mount
XY = Back Plate Mounting
Figure 5: Back Plate Hole Pattern
5
Summary of Contents for TECH 7 MS770
