Metrologic Stratos MS2 Series, Configuration Addendum, Page: 11 / 88

6
S
CALE
/L
OAD
C
ELL
C
ONFIGURATION
B
AR
C
ODES
Single or Dual Cable Scale Configuration Bar Codes
Pole Display Configuration
The following bar codes can be used to configure a Single or
Dual Cable MS2xx0.
The MS2xx0 must be in scale program mode to use these bar codes.
Scale Has Display
³ 9 9 6 0 0 3
Set the scale to use a remote display to
show all scale activity.
A remote display
must be plugged into the
Scale RS485 to Display connector on the
MS2xx0 ( see Figure 7 ) for this feature to
function properly.
Figure 7. Location of Scale RS485 to Display Connector
Scale Has No Display
³ 9 9 6 0 0 4
Set the scale to not use a remote display.
All weights are expected on a POS terminal
display.
A remote display can not be plugged into
the Scale RS485 to Display connector on
the scanner/scale ( see Figure 7 ) or this
feature will not function properly.