Autolab/Electronic load combination
24 |
P a g e
Figure 16 – The conversion settings for control of the Kikusui PLZ164WA electronic load
These settings indicate that in order to control the setpoint of the electronic load,
the specified current needs to be divided by -3.3 in order to be converted to the
analog signal with the correct polarity. Upper and lower limits can be specified,
these are defined by the electronic load.
10
– Manual control of the electronic load (DC only)
Manual control of the electronic load is possible in NOVA provided that the
settings are specified correctly (see Section 9).
To open the manual control of the electronic load, select the
External manual
control option from the View menu (see Figure 17).
Note
It is possible to save these settings in the Hardware setup for future use by
clicking the button on the right-hand side of this panel.
Note
The parameters for other electronic loads are reported in the Appendix of this
document.
