Metrohm 785 DMP Titrino, Instructions For Use Manual

Page: 7 / 182

2.1. Keypad
785 DMP Titrino
4
2 Manual operation
2.1 Keypad
6.2132.070
The third functions (inscriptions in the triangle) on the keys of the keypad are used for
formula entry, see page 38.
SILO
–
9
STATISTICS
EP
7
MEAS/HOLD
+
8
USER
SMPL
DATA
PARAM CONFIG
→ ↑ ←
CLEAR ENTER ↓
STOP START QUIT
CARD
/
6
CAL.DATA
*
5
RS
4
USER METH
)
3
DEF
(
2
C-FMLA
C
1
MODE
;
–
REPORTS
ABC
.
PRINT
MN
0
CONFIG Configuration.
PARAM Parameters.
SMPL DATA Sample data.
STATISTICS ON/OFF switching of statistics calcu-
lations of consecutive determination,
see page 41.
MEAS/HOLD ON/OFF switching of measurements
between titrations and hold during ti-
trations.
SILO ON/OFF switching of silo memory for
sample data, see page 60.
CAL.DATA Calibration data, see page 58.
CARD Management of memory card, see
page 55.
C-FMLA Calculation values, see page 40.
DEF Formulas, data output, sequence for
TIP, see page 38ff.
USER METH Management of internal method mem-
ory, see page 53.
PRINT Printing of reports, see page 45.
REPORTS Result output.
MODE Mode selection, see page 13.
USER User name, see page 48.
CURVE Switching result/curve display.
←
,
→
Selection of special values (dialog
marked with ":")
↑
,
↓
Cursor key for navigation.
CLEAR Clears values, set special values.
ENTER Stores values.
STOP Stops methods.
QUIT Quits inquiries, waiting times, printing.
START Starts methods.
CURVE