￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
942 Extension Module Vario SeS/PP (2.942.0500)
￭￭￭￭￭￭￭￭
29
3.6.2
Connecting the MCS
The MCS is connected between the Metrohm Suppressor Module (MSM)
and the conductivity detector.
Connecting the MCS
Figure 10
Connecting the MCS
1
Air aspiration capillary
For drawing in air with low CO
2
content (via
the CO
2
adsorption cartridge).
2
Pressure screw, short (6.2744.070)
Installed on the air aspiration capillary.
3
Luer coupling (6.2744.120)
Mounted on the air aspiration capillary with
a pressure screw (6.2744.070).
1 Removing the threaded stoppers
Remove and keep the two threaded stoppers (6.2744.220) from the
inlet and outlet of the MCS.
2 Connection from the suppressor
Use a long pressure screw (6.2744.090) to connect the capillary of
the MSM labeled
out
to the input of the MCS (labeled
In
).
3 Connection to the detector
Connect the inlet capillary of the conductivity detector with a long
pressure screw (6.2744.090) to the MCS output (labeled
Out
).