Metrodata ATM CBR DSU, User Manual

Page: 79 / 128

REMOTE MANAGEMENT (SNMP, TELNET)
69 76-02-031E
7 REMOTE MANAGEMENT (SNMP, TELNET)
In addition to using the terminal port, the ATM CBR DSU may be managed remotely by using
a LAN-based network management system. The LM1100 SNMP Enabler option is fitted as
standard to the DSU.
The operating parameters, event log, performance statistics database and diagnostics
functions are known collectively as the Management Information Base (MIB). The DSUs MIB
can be accessed remotely by using a Network Management System (NMS). The NMS
should use SNMP (Simple Network Management Protocol), and could be located on the
local LAN or on a remote LAN connected to the local LAN via a LAN bridge or IP router.
When the SNMP Enabler is fitted to the DSU, the MAIN SET-UP menu contains the option
MANAGEMENT.
Figure 7.1 Main set-up menu
The MANAGEMENT menu leads to a series of menus which permit you to configure the
various system management protocols and parameters.
For further information on the management interface and the MIB definition, refer to the
LM1100 SNMP Enabler user manual.
The Metrodata MIB definitions supported have been placed in the public domain by
Metrodata and can be parsed in to any NMS supporting an ASN.1 MIB parser.
MAIN SET-UP
alarm eXtension
General set-up
WAN port set-up
DTE set-up
V.24 set-up
Management
Testing
Special
Performance data
HIGHLIGHTED letter - select item
<escape> - exit menu