Glossary
521
Figure 466: Phase Cancellation
Post
Means “after”. Common uses:
• Post-fader: After the fader. A post-fader meter would show the level
of an audio signal including the boost or cut of the fader.
• Post-insert: After the insert. A post-insert direct out would send wet
audio.
PPM meter
Peak Program Meter. This type of audio meter features a fast response,
allowing you to see peak signal level and catch potential overs quickly.
Pre
Means “before”. Common uses:
• Pre-fader: Before the fader. A pre-fader meter would show the level
of the audio before the fader, so the meter’s display would not show
boost or cut from the fader.
• Pre-insert: Before the insert. A pre-insert direct out would send dry
audio.
See also
Mic Pre
R
RCA
A two conductor connector, sometimes called a phono connector. RCA
connectors use a two conductor (often coaxial) cable to carry unbalanced
signals, and are wired with signal to the center pin and ground to the ring.
Inputs and outputs are both on female (jacks) and interconnect cables are
male to male (plugs). Extensions are male to female.
S
Scene
A “picture” of your MIOConsole3d setup. All your routing, fader levels,
DSP plug-ins, etc. are saved so that they can be quickly recalled. This
can be done by saving from MIOConsole3d using “File/Save” and “File/
Open” or from your DAW using MIOConsoleConnect.
