The DSP Toolchest
404
Parameters:
Volume
[-120, 20] dB
Specifies the gain applied to the input signal.
Glide
[0, 1k]
Specifies the rate at which the gain will change. If the Glide value is close to 0 (especially
between .1 and 1), the gain will change slowly. If Glide is close to 1000, the gain will change
quickly.
Master Bypass
{On, Off}
When bypassed, the gain will be set to 0dB, passing the input signal unchanged.
MIO M/S Processor
• Synopsis: Mid/Side Processor
• Category: Spatial, Building Blocks
• Channels: 2
Description:
MIO M/S is a flexible Mid/Side channel processor. It can be used to decode material that was
previously encoded as Mid/Side. It can also be used to encode a left/right stereo field into a mid/
side signal. In addition to being used to encode or decode existing signals, it you also use two
instances of MIO M/S to build a transcoding signal chain in the 3d DSP graph.
Since you have access to the individual Mid and Side signals after encoding, you can insert addi-
tional processing blocks between the encoder and the decoder, including EQ, delay, compression
and limiting. This allows you to build signal chains that alter the overall size, nature and depth of
the stereo field.
Parameters:
Enable
{Off, On}
When engaged, enables all the processing of the module.
Mid Invert
{Off, On}
When enabled, inverts the 1st input channel before processing.
Side Invert
{Off, On}
When enabled, inverts the 2nd input channel before processing.
Mode
{Decode (Constant Amplitude), Decode (Constant Power), Encode (Constant Amplitude),
Encode (Constant Power), LR->MS->LR}
Selects the processing mode.
Decode (Constant Amplitude)
Makes input 1 be the Mid Channel and input 2 the Side Channel. In this mode, the proces-
sor decodes the M/S input to Left and Right outputs, keeping the total amplitude constant.
The center point is output compensated to avoid clipping.
