5
6
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
Re-connect the battery terminal and test the unit
for proper operation. Mount the head unit/kit
assembly to the sub-dash with (4) screws
previously removed in step #1.
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
3
99-7407
INSTALLATION
INSTRUCTIONS
APPLICATIONS
CAR
PAGE
NISSAN
240SX 1989-94........................................................... 1
Maxima 1989-94.........................................................1
Stanza 1987-89...........................................................2
KIT COMPONENTS
TOOLS REQUIRED
Cutting tool
Wrench
Phillips screwdriver
Faceplate
#1
Faceplate
#2
Equalizer
Dummy Plate
4
Fig. B
Fig. A
Radio Housing
KIT FEATURES
Shaft and
DIN unit
provisions
Equalizer
provisions
IF AN EQUALIZER WILL BE INCLUDED:
Slide the aftermarket equalizer into the back of the
Radio Housing.
Using the hardware included with the equalizer, mount the unit to the kit.
(see Fig. A)
IF AN EQUALIZER WILL NOT BE INCLUDED:
Snap the
Equalizer Dummy Plate
into the
Radio Housing.
(see Fig. B)
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
rev. 100103
