Metos WD-6E, Installation And Operation Manual

Page: 12 / 52

5HY
2SHUDWLRQ
12
2SHUDWLRQ
*HQHUDO
Before using the dishwasher, see also “After installation” in Chapter “Installation”.
2SHUDWLRQSURFHGXUHV
7RILOOZLWKZDWHU
• Check that the machine is cleaned and that no soil exists in the nozzles of the wash
arms.
• Put the drain strainer (12, only in types with drain pump), overflow pipe (11) and
tank strainers (10) in place. Check the amount of detergent and rinse aid.
• Press ‘0/1’. Close the hood. The display (2) shows the water temperature. When
the temperature has reached 85°C, the filling of water starts. The filling time varies
from 3 to 16 minutes depending on the temperature of the incoming water. The
tank is filled when the water level indicator (3) is lit. At the same time the washing
temperature is displayed on the display (2).
• Correct working temperatures are: wash = 60°C, rinse = 85°C. To check the rinse
temperature: Keep 'P1' pressed for a couple of seconds. The rinse temperature is
displayed on the display (2).
&KRLFHRIZDVKSURJUDPPH
• Choose wash programme P1, P2 or P3. Programme P3 is selected by pressing P1
and P2 simultaneously. P1 = Slightly dirty goods, P2 = Normal washing, P3 = Ex-
tremely dirty goods.
• P0 = Pause position. This is used during longer breaks. The hood must be closed.
When switching to P0, press the program button which is shown on display (2).
:DVKLQJ
• Place the goods to be washed in the rack. Place the dishes correctly in the rack:
deep plates in the rack for deep plates, cups in the cup racks etc. Rinse with a hand
sprayer to remove large food scraps.
• Push the rack into the machine. The washing cycle starts when the hood is lowered.
If the hood is lifted during the washing cycle, the washing stops.