34
Probe Active Threshold
The “Probe Active Threshold” defines the zone(as a diameter)around a target edge position in playback,
where the probe becomes active. The probe active state is identified by a green “playback position dot”.
When green the Mx200 playback system will freely accept entered edges to the system. When the
playback position dot is red, edge points will not be entered into the system.
•
Set the threshold value by selecting the menu item, entering the numeric value for your size of
your playback active zone, and then pressing the “OK” softkey
4.6
Quick Keys
The “Quick Keys” settings screen is where the mapping of Mx200 functions to keypad keys and
footswitch buttons can be configured.
Number Pad
Use the Number Pad quick key page to assign a specific part program to a number key on the keypad.
When assigned, that number pad key will automatically load and play the corresponding part program
number. To assign a number from the keypad to a part program;
•
Select the “Number Pad” item from the Quick Keys settings menu.
•
Choose the number pad number you would like to assign your program to. “0” through “9” will
be available for assignment.
•
Press the “Assign” softkey.
•
At the next prompt enter the desired program number that you would like to assign the keypad
number to.
•
Press the “Ok” softkey to confirm the selection.
Note
: The Number Pad Quick Key loading of part programs will only be permitted while in the main DRO
view. This is to prevent undesired calling of a program while using other Mx200 screen. While in the
main DRO view press the number pad key associated with your program, it will be loaded and run.
