Methven warrants this product against manufacturing defects and that it is suitable for use
under the general operating conditions specified in this instruction sheet. However, regional
regulations apply and may affect your warranty. Please refer to
www.methven.com
or call
customer service for full details.
New Zealand
0800 804 222
Australia
1300 638 483
UK
0800 195 1602
www.methven.com
Care and Cleaning:
439949
ISSUE A
Technical Specifications:
Operating Pressure:
Min: 100kPa/1.0bar
Max: 500kPa/5bar*
Operating Temperature:
Hot: Max 70°C*
Cold: Min 5°C
Inlet Connections:
All ½" BSP
* Regional specific regulations apply.
Please refer to your warranty statement at
www.methven.com
Installation Guide
AURAJET™ SHOWER SYSTEM
Optimum: 150kPa/1.5bar - 500kPa/5bar
1
2
Run hot water through shower for 2 minutes before first use.
Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with warm
soapy water and a damp soft cloth.
Clean filter washer located in the shower hose and in the overhead shower periodically. To access
filter washer in overhead shower, push down on release button, hold the elbow bracket and pull
shower head away from it.
Remove filter washer from the shower head waterway
by gently levering out with a small screwdriver.
If shower performance is compromised by the build-up of lime-scale, soak in limescale remover for
up to 10 minutes. Do not attempt to remove limescale with sharp objects or abrasives. Do not use
products containing chlorine bleach or hydrochloric acid as these can damage the shower. Always
rinse the shower thoroughly after cleaning to remove cleaning products that can damage the shower.
Refer to instructions above for how to remove overhead shower from elbow bracket.
Never insert objects into the spray slot or attempt to remove spray cover as this may cause damage
to shower components.
Do not hang any items or pull down on the overhead shower. This may cause damage to the
overhead shower.
