51
TECHNICAL DATA
Mains voltage V
230
Mains frequency Hz
50
Power input W
2000
S2 2min 2400W
No load speed min
-1
4350
Max. speed rating saw blade min
-1
6000
Saw blade diameter mm
305
Blade bore mm
30
Cutting Capacities
90° Straight
340X90mm
45° Miter
340X48mm
45° Straight Bevel
240X90mm
45° Compound (L/R)
240X48mm
Weight
Kg
19
Noise emission values measured
according to relevant standard.
Acoustic pressure level
LpA 93.2 dB(A) K = 3 dB(A)
Acoustic power level
LwA 106.2 dB(A) K = 3 dB(A)
ATTENTION !
The sound power pressure
may exceed 85 dB(A), in this
case individual hearing
protection must be worn.
Weighted root mean square acceleration
according to relevant standard. :
1.778 m/s²
K=1,5 m/s²
The declared vibration total value
has been measured in accordance with a
standard test method and may be used for
comparing one tool with another that the
declared vibration total value may also be
used in a preliminary assessment of
exposure.
A warning that the vibration
emission during actual use of the power tool
can differ from the declared total value
depending on the ways in which the tool is
used and of the need to identify safety
measures to protect the operator that are
based on an estimation of exposure in the
actual conditions of use (taking account of
all parts of the operating cycle such as the
times when the tool is switched off and
when it is running idle in addition to the
trigger time).
SERVICE DEPARTMENT
_ Damaged switches must be replaced by our
after-sales service department.
_ If replacing the power cord is necessary, it
should be done by the manufacturer or his
agent to avoid a hazard.
AFTER-SALES SERVICE AND APPLICATION
SERVICE
Our after-sales service responds to your
questions concerning maintenance and repair
of your product as well as spare parts.
Exploded views and information on spare parts
can also be found under:
www.eco-repa.com
METAWOOD application service team will
gladly answer questions concerning our
products and their accessories :
CARRYING TOOL
Make sure that the tool is unplugged. Secure
the blade at 0° bevel angle and the turn base at
the full right miter angle position.
Lower the handle fully and lock it in the lowered
position by pushing in the stopper pin.
