Owner’s Manual
7
Fig.1
6. INITIAL ASSEMBLY
Upon initial receipt of the equipment, some assembly may be required, check the
following:
6.1 HYDRAULIC HOSES
The equipment may require additional hydraulic hoses from the vehicle to the snow
plow. It is the responsibility of the user to supply these. Hydraulic hoses must be
routed and positioned in a way that they do not bind with mobile parts of the equip-
ment. In certain conditions, it is recommended to add supports or protective sheath
to to keep the hydraulic hoses protected.
(Fig.2)
Warning:
Diverter valves are available in 12 or 24 volts. Verify the coils on the
valve to appropriately feed the correct voltage.
Warning:
The fuse associated with the power source must not exceed 10 amps.
Vehicle
Relief valve
A1 (P1)
B1
C1
C1
C2
C2
B2
A2 (P2)
Relief valve
Relief valve
Fig.2
Hydraulic system
diagram
The initial installation is done by Metal
Pless. However, it is recommended to
confirm that the assembly of the hydraulic
system matches the diagram.
