Metacon-Next
OHD-C EI(1) 60 / EI(2) 90 / EW 90
18-05-2021
User manual
art nr: 89022
Rev: 2
31
9
First use
The first use of the door is performed by the installer. Immediately after installation, they
must fill in the document 'Annex A' and leave it with the door.
The door must be checked on the basis of the check/maintenance list and each step must be
ticked off and signed, including the checker’s name in block letters.
Upon commissioning, the door will have a sound pressure level of 70 dB(A) or lower.
If this check is positive on all points, the door can be handed over to the user.
10
Maintenance, malfunctions and repairs
10.1
Regular maintenance
Each door is provided with an identification showing the type of door, the order number and
item number. In the event of any malfunctions, this number must be passed on to the
supplier. Metacon keeps a technical dossier in its archives with references to the order
number and item number.
Regular maintenance is required for the correct functioning of the installation. In order to
make a claim under the manufacturer's warranty, maintenance must be carried out at least
once a year during "normal" use. Maintenance must be carried out by a competent installer.
Metacon recommends concluding a maintenance contract with the supplier. Insufficient
maintenance can lead to an unsafe situation. See NEN-EN 12635.
The following steps should be checked during maintenance (and first use):
Annex B "Door type - maintenance instructions".
10.2
Cleaning
The frequency at which the door is cleaned can be determined by the user. It is
recommended to wipe the door once a year using only a damp cloth to prevent any damage.
Use of other cleaning methods will void the manufacturer's warranty. Make sure that
electrical parts do not come into contact with moisture during cleaning. Attention: climatic
conditions may require a different cleaning frequency.
10.3
Malfunctions and repairs
During maintenance and repair work, the door must be powered down. Troubleshooting and
repairs must be carried out by a competent installer. In case of a malfunction, the supplier
should be contacted. If the supplier cannot remedy the fault, Metacon can be contacted.
