Intercom
Operating Instructions
Signal I/O
Connection of console device
Socket SUB-D
7.10 Initial Operation
•
Turn the “Volume out” knob on both devices completely to the left
•
Switch on both devices → Info LED stops blinking when an optical connections is established
•
Press and hold “Volume In” knob (> 2s) on both devices to reset settings to default → Info LED blinks once
•
Push and release the PTT button (< 250ms) on console device to start talking → Power LED blinks
•
Turn the “Volume Out” knob on mobile device to adjust the speaker volume
•
If necessary, turn the “Volume In” knob on console device to adjust the mic gain
•
Switch the “Mic” button to “On” on mobile device to start talking → Power LED blinks
•
Turn the “Volume Out” knob on console device to adjust the speaker volume
•
If necessary, turn the “Volume In” knob on mobile device to adjust the mic gain
•
Wait at least 20s until mic gain is stored in the devices
§
Speaker Damage when volume is too high
A too high speaker volume can lead to extreme loudness or an overload of the speaker. When
taking the devices into operation, turn off the speaker volume in order to avoid any damages.
Page 14 / 23
Distributed by: Reliant EMC LLC, 3311 Lewis Ave, Signal Hill CA 90755, 4089165750, www.reliantemc.com
