Messoa NCB355, Quick Manual

Page: 7 / 18

Quick Start Guide
6
2.2.2 Mounting the camera

Please insert the screws into the mounting block and either top or bottom holes of the unit. Securely
fasten the screws to ensure the mounting block is connected with the unit tightly. Select a bracket (sold
separately) which has a standard thumbscrew matching the threaded receptacles of the mounting block
and tighten them. Depending on different applications, mount your selected bracket onto wall/celling to
complete mounting procedure.

Connect the Safety Wire (Fall Prevention Wire, not supplied) with one end to the wall/ceiling and the
other end to the safety-cord screw of the unit.
Figure 2 - 1: Mounting the Camera
Note
To prevent the unit from falling off, ensure that it is mounted to a firm place (ceiling slab or
channel) using a safety wire strong enough to withstand the total weight of the unit. (Pay also
attention to the finishing at the end of the wire.) By cabling so, it is possible to prevent the unit
from accidental falling suddenly at any time.
Safety wire (fall prevention wire, not supplied)
Safety-cord screw of the unit