MEA
VMM
User’s
Guide
All of these schemes may be assigned per device, either by the user or by the network
manager. The network manager can also limit the user-selectable schemes or force a specific
scheme. Devices in each of these schemes can interoperate and communicate with each other,
so long as the assigned addresses do not conflict and are mutually routable.
3.1.2.5
Setting the User Supplied IP Address
In order to set the user-supplied IP address for the VMM, the User-Supplied radio button must
be selected. At that point, the user may enter an IP address, subnet mask consistent with the
existing network. The user should also enter the IP address of the default gateway and DNS
server, as well as enter the domain name.
Note that this configures the user-supplied address for the VMM device. To configure addresses
for ethernet clients, please refer to the description of the
External Device Provisioning
frame of
this web page in .
A similar screen will be displayed for the access account (the web page will indicate
Normal
User
Login). Normal users can change only those settings for which they have system
privileges.
When the desired configuration has been completed, click on the
Apply
button on the
Device
Addressing
panel on the Device Administration Configuration Page. You will be prompted to
verify that the changes to the configuration are correct before the changes are actually applied.
Figure 3-5.
Configuration Change Dialog
When you click on the
OK
button, the configuration will be saved in Flash. The
System
Settings Have Been Saved
message on the
System Update Save Completed
page will then
confirm the changes have been saved.
13
