Mesa Labs Smart-Well Model 1710 Operation Manual - 9153 Rev E
8
3.
If a plug adapter for your environment was included with the kit, attach the plug adapter to the
printer power pack.
Note: You may have to supply an appropriate plug adapter for your environment if one was not
included with the kit.
4.
Plug the printer power pack into a power outlet.
LOADING THE PRINTER RIBBON CASSETTE
1.
To remove the printer cover, grasp the protrusion at the rear of the cover and lift up.
2.
Press down on the ribbon cassette while inserting the ribbon between the printing head and
platen (see Figure 1). The ribbon cassette will click into place.
3.
Wind up the ribbon slack by turning the knob on the left side of the cassette in the direction of
the arrow that appears above the knob (see Figure 1).
Figure 1. Loading the Printer Ribbon
4.
To remove the ribbon cassette, remove the printer cover and pull up on the cassette where
indicated by the word
PULL
.
LOADING PAPER
1.
To remove the printer cover, grasp the protrusion at the rear of the cover and lift up.
2.
If the printer is turned off, switch it on.
3.
Press the
SEL
button until the
SEL
light is off.
4.
Hold the paper roll such that the paper unwinds towards you from the bottom of the roll.
