Meru Networks AP1000 SERIES, Installation Manual

Page: 34 / 135

20 Meru Access Point Installation Guide
© 2010 Meru Networks, Inc.
Install the AP300
Figure 8: Remote Antenna Mount
The remote antenna mount kit includes:

Antenna stand with attached cable. The three antenna SMA female connectors on the Antenna
Mount support AP300 antenna diversity. This feature gives the client the ability to automatically
choose the antenna receiving the strongest signal.

Triangular ceiling mount clip for attaching to hanging ceiling (includes bolt assembly)

Three self-adhesive pads for the bottom of the unit (over the screws)

Two wall mount screws with anchors

Ceiling Mount Template

Installation diagram
Install the Remote Antenna Mount on the Ceiling
To connect the Remote Antenna Mount to the ceiling, refer to the installation diagram from the ship-
ping box while following these steps:
1.
Attach the shorter end of the screw to the center hole on the back of the Antenna Mount.
2.
Remove the designated ceiling tile.
3.
Using the template, drill holes in the ceiling tile.
4.
Replace the ceiling tile.
5.
Remove a ceiling tile adjacent to the newly drilled tile for access purposes.
6.
Feed the Antenna Mount cable through the larger hole in the ceiling tile until the Antenna Mount
is flush with the ceiling. The screw should now be visible above the ceiling tile (through the second
hole).
7.
Place the triangular plate above the ceiling tile with the screw aligned through the plate.
8.
Drop the washer onto the screw and tighten the bolt.
The Antenna Mount is now connected to the ceiling.
9.
Replace the adjacent tile.
00224