- 73 -
U.motion KNX Server Plus, Touch
Installation Manual
MULTIROOM ZONE
Permits to combine into a single pop-up all control objects of a Multiroom audio zone,
connected via KNX:
GENERIC
Allows grouping several objects into a pop-up window, where the structure and the
objects to be shown can be freely chosen (refer to the appropriate chapter of this
manual)
Depending on the selected TEMPLATE, only compatible objects can be added, since the COMPLEX OBJECT needs to
understand where each object must be positioned and which functionality they will have to assume; for the available
functions of a COMPLEX OBJECT, only compatible objects can be used.
8.3
O
BJECT
A
SSIGNMENT
Once a COMPLEX OBJECT is defined, the desired objects can be inserted into the area "OBJECTS CONTAINED IN THE
COMPLEX OBJECT" for being assigned to one of the functions the COMPLEX OBJECT offers. Search for the desired objects
with the search function and pull them inside the area ("drag and drop"). Each object must be assigned to the
corresponding function of the COMPLEX OBJECT. In the parameter "FUNCTIONALITY" the corresponding function for an
object can be selected; the available functions will depend on the objects type; for example if a 2-byte temperature value
was added, you could select only between the functionality "Measured temperature" or one of the "set point"
functionalities (but not the operating mode, since it is either a 1byte or different 1bit objects).
The entry in the column
“FUNCTIONALITY” also defines the graphical aspect of the related sub-object.
Naturally it is still possible to change the function of the sub-object also in a second moment; in this case also
the visualisation within the complex object will change. By re-changing the entry of the column
“FUNCTIONALITY” of the selected sub-object, also the graphical aspect of the sub-object will change again.
It is furthermore possible to add sub-objects to a complex object directly through an ADD button in the
section of the contained objects. This will create a VIRTUAL OBJECT (check out chapter 11.4 for details) and
connect it with the complex object. The graphical aspect of the new sub-object can be defined directly
through the entry within the column “FUNCTIONALITY”.
Since this objects are virtual objects, they will not send any commands to the system (like for example KNX
objects), but are primary used for labeling or demonstration purposes.
