- 54 -
U.motion KNX Server Plus, Touch
Installation Manual
5.8
KNX
S
CENARIOS
Objects of type 1 byte during the ETS import can be defined as KNX scenarios. With these objects no status feedbacks or
single commands are transferred, but a number, usually between 1 and 64, which tells the installed devices the KNX sce-
ne they should load from their memory; all states saved for the loaded scene will be set from the device. Some KNX de-
vices can save various states for such a KNX scenario. Depending from the value they receive on the group address of the
scenario, they can launch different actions and set different states of functions.
A KNX object can be defined as KNX scenario as follows:
Open the ADMINISTRATION menu and open the desired object (1byte) in a new tab
Activate the EXPERT mode
Ensure, that the “ETS ENCODING” is set to “Scaling - 0-100% (1byte)”
Configure the parameter FUNCTION“ to “SCENARIOS“. If this entry should not be available, change the “ETS EN-
CODING” to another value and then back to “Scaling - 0-100% (1byte)”.
Select an appropriate icon
Set the value for the scenario to send on the bus when it is activated in the input field “VALUE KNX SCENARIO“
Once a KNX scenario is configured it will appear in the VISUALISATION as shown below:
By clicking the PLAY button, the value configured for the parameter “VALUE KNX SCENARIO” will be sent to the KNX bus
and the KNX devices configured for the usage of the KNX scenario will start the actions memorized for the received val-
ue. By clicking on “UPDATE”, all status of the involved KNX objects are stored to the KNX devices. This way you got the
same possibilities inside the VISUALISATION as present in the KNX-Installation for a KNX scenario (also called “light-
scene”): start a scenario or update a scenario.
