- 28 -
U.motion KNX Server Plus, Touch
Installation Manual
3.3
N
ETWORK
This page allows the configuration of the network parameters of U.motion KNX Server Plus Touch:
The available parameters are:
IP ADDRESS
IP address of U.motion KNX Server Plus Touch; this address must be present in the
network only once and must be compatible with the IP addresses of the other
devices inside the same network (if unsure, please contact your network
administrator)
SUBNET MASK
If no special network configuration is used, don’t change the standard value
“255.255.255.0”
GATEWAY
Enter the IP address of your router (if present) or the referenced server of the
network (if unsure, please contact your network administrator).
NOTE: in order to guarantee remote access to U.motion KNX Server Plus Touch, you
must enter the IP address of the Internet router, through which you want to access
the web server. For more details, see the appropriate section of this manual.
PRIMARY DNS
SECONDARY DNS
DNS addresses over which U.motion KNX Server Plus Touch can access the internet
(if available). If no connection is possible with the default addresses, please contact
your network administrator.
After modifying the single parameters, please click on "SAVE". If the IP address was changed, the new IP address must be
entered in the address bar of the browser for reconnecting with the webserver. Please ensure that all entered data is
correct before you save them. If incorrect settings are saved, U.motion KNX Server Plus Touch will probably be no longer
accessible through the network.
