MERQUIP COSMETAL H2OMY IN F, Installation, Use And Maintenance Handbook

Page: 12 / 22

Warning! Before using the machine proceed
with the sanitation (see relative paragraph).
6 STARTING GB
Warning! If the appliance has been laid down or turned upside
down, you should wait at least 8 hours before starting it.
6.1 ELECTRICITY CONNECTION
Connection to the mains electricity supply is carried out by connecting the
plug to a mains socket. The supply socket must be equipped with an ef-
¿FLHQWHDUWKSODWHDQGLWPXVWEHVL]HGIRUWKHORDGRIWKHDSSOLDQFHVHH
technical characteristics).
0DNHVXUHWKDWWKHPDLQVYROWDJHFRUUHVSRQGVZLWKZKDWLVVSHFL¿HGRQWKH
data plate. Make sure that there is an omnipolar switch above the socket with a
minimum contact break of 3 mm protected by fuses of suitable amperage for the
absorption of the appliance itself (see technical characteristics and data plate).
‡ Turn on the water tap and make sure there are no leaks.
‡ Turn on the main ON/OFF switch 4 .
‡ Turn the tap to the position marked to eliminate all remaining air in
the soda water circuit (WG models).
13 14
IN CO
2
16 15
R
5
4
‡ Turn the tap to the position marked to eliminate all remaining air in
the cold water circuit.
‡ Adjust cold water thermostat 5 depending on use and season (positions
recommended from 4 to 7).
‡ Connect the machine to a mains electrical network protected by a circuit
breaker with a sensitivity equal to or less than 30 mA.
6.2 CO
2
GAS CYLINDER CONNECTION (CARBON DIOXIDE)
In this water cooler model, the CO
2
can be connected only outside the ma-
FKLQH¿JDOORZLQJWKHXVHRIUHFKDUJHDEOHF\OLQGHUVDVZHOO
CAUTION: do not pass the cylinder’s connecting pipe in front of the
KHDWRXWOHWYHQW¿J
‡ Take the ø6 mm pipe out of the installation kit and connect it to the R
SUHVVXUHUHGXFHURQWKHF\OLQGHU¿J
‡ Insert the other end of the pipe on the IN CO
2
connector at the top of the
device; make sure you insert it correctly.
The cylinder is provided with a sealing valve which will open during reducer as-
sembly and will close automatically during disconnection. The reducer regula-
tion screw R is already calibrated in the optimal pressure setting (approximately
3.5 bar). In any case, the quantity of gas supplied can be increased by turning
the screw in the clockwise direction, and vice versa. 600 g. rechargeable CO
2
cylinders can charge approximately 120 liters of water.
12