12
Common properties of SSM-6 Servo motors:
•
Digital angle indicator,
•
Locking settings with user password,
•
Retrospective error information for 10 different operating systems,
•
Programming through buttons on the motor,
•
Possibility to set between 0° and 90° at 1° increments,
•
Manual control through buttons on the motor,
•
Motor’s direction of rotation settable as CW or CCW,
Setup and mechanical installation :
Do not apply any thermal insulation to the servo motor!
Install in a vertical or horizontal position. Do not install upside down!
Before installation, check the conformity of the power of the motor to the working area!
Check that the connecting rods and joints are compatible with the motor’s output shaft!
If the servo motor is to be installed directly, suitable screws must be used. Using the wrong
screw may damage the product. Refer to
Figure 3
for screw sizes.
Do not attempt to install by hitting or forcing the motor shaft!
SSM-6 motors should have gapless interconnecting fittings to maintain position sensitivity
and make this feature useful!
Make sure that cable inputs are compatible, and have not been modified or altered in any
way.
3 x PG9 waterproof plastic unions are supplied with SSM-6 motors, and can be found in the
packing box. The cable entry holes to the motor are temporarily closed with a plastic plug.
Do not remove the plugs unnecessarily! Always connect only the supplied PG9 unions to
the cable entry points after removing the plugs!
If there is no suitable o-ring in the union or the appropriate cable is not installed, the
protection class of the SSM-6 servo motor becomes void, as the negative effects of
moisture, dust, water, etc. entering the motor may cause faults!
CAUTION
