Meritor T-2111 Series, Maintenance Manual, Page: 41 / 46

Page 35
Section 8
Specifications
Driveline Application Guideline
NOTE:
All of the options shown below may not be
available for each transfer case configuration.
The values given are for Rockwell manufactured
parts. If parts from other manufacturers are used,
torque values may be different.
WING STYLE MAX TORQUE
YOKES RATING (Lb-ft) FLANGE STYLE
62N 5,000 (6779 N•m)
58WB 7,025 (9561 N•m)
72N 7,080 (9599 N•m)
82N 11,080 (15022 N•m)
85WB 12,500 (16948 N•m)
92N 23,000 (31184 N•m)
3WCS
3WCS
8 BOLT
5 WCS
12 BOLT
FULL ROUND (NYS) MAX TORQUE
EASY SERVICE (TYS) RATING (Lb-ft) FLANGE STYLE
STYLE YOKES
131 NYS and TYS 1,950 (2644 N•m)
133 NYS and TYS 2,330 (3159 N•m)
135 NYS and TYS 3,080 (4176 N•m)
141 NYS and TYS 3,750 (5084 N•m)
148 NYS and TYS 5,000 (6779 N•m)
155 NYS and TYS 6,250 (8474 N•m)
16 NYS and TYS 7,100 (9626 N•m)
17 NYS and TYS 9,600 (13016 N•m)
176 NYS and TYS 16,000 (21693 N•m)
18 NYS and TYS 21,000 (28472 N•m)
3WCS
3WCS
8 BOLT
5 WCS
12 BOLT
Driveline Length Guideline
Smallest yoke sizes (131 Series): Maximum driveline
length of approximately 48 inches (1.2 m).
Largest yoke sizes (92N Series): No more than an 80
inch (2.03 m) long driveline. Other maximum driveline
lengths should fall between these values, increasing
with relative size.
Maximum Driveline Angle
Guideline
NOTE:
Values shown below are guidelines only for two
joint shafts without mismatch. For more detailed
information on performing driveline calculations
refer to Rockwell publication SP-7711. Final
approval should be made with Rockwell’s
Driveline Engineering Department.
DRIVELINE MAXIMUM OPERATING
RPM ANGLE (DEG)
4000 4.25
3500 5.00
3000 5.85
2500 7.00
2000 8.65
Pro Gear and Transmission • 906 W. Gore St. Orlando, FL 32805 • 1 (877) 776-4600 / (407) 872-1901 • parts@eprogear.com