Meridian M3900 series, Installation And Administration

Page: 73 / 88

Installation Page 73 of 86
M3900 Series Telephones Description, Installation and Administration
4 Select Run.
5 Enter a:\setup (assuming that drive “a” is your floppy disk drive).
6 Click on OK. The Nortel Networks logo screen appears while the
installation utility loads.
7 The Welcome screen appears. Click on Next to continue installation.
8 If you agree to the terms of the Software License Agreement, click on
Yes.
9 Continue to Click on Next until the installation is complete.
10 When asked to, remove the disk from your floppy disk drive.
11 Click on Finish.
Note: You must restart your PC to access the Personal Directory PC
Utility.
12 To select a port for the Personal Directory PC Utility; click on Phone.
Click on Set port. The pull-down menu shows available PC ports:
• Com1
• Com2
Note: The program selects the same port each time until you change
it.
To install the Key-based Expansion Module
The Key-based Expansion Module provides 22 additional line/feature keys
for the M3904 and M3905 Meridian Digital Telephone. You can add up to
two Key-based Expansion Modules providing a total of 75 line/feature keys.
To install the Key-based Expansion Module:
1 While depressing the telephone tilt handle, pull the telephone away
from the footstand until it clears the final stop. Gently pull the footstand
off the clips.
Note: If an ACM is installed, leave the ACM cable plugged into the
telephone, and swing the front edge of the footstand under the ACM
cable to access the 10-pin slot.
2 Place the telephone and the Module face down on a padded level
surface, and align them.